Flame Amplifier R7847C1005 for C7027-35
Honeywell R7847C1005 solid state plug-in amplifiers respond to flame detector inputs to indicate the presence of flame when used with 7800 SERIES relay modules.
Compatible with existing Honeywell flame detectors (order separately).
Use with Flame Sensor; gas, oil, coal: Ultraviolet Flame Sensor C7012E, F
Flame failure response time of 0.8 or 3.0 seconds.
Flame signal strength ranges from 0.0 to 5.0 Vdc.
Plug into 7800 relay module through printed circuit board edge connector keyed for proper orientation.
Flame signal test jacks to measure amplifier flame signal voltage.
Colour-coded labels identify flame detection type. Dynamic Self-Check Amplifier test the detectors and all electronic components in the flame detection system 7800 SERIES relay module locks out on safety shutdown with flame detection system failure.
Consult the attached pdf for further specifications.